Radwag PUE C/31H/Z Indicator Manual de usuario descargar pdf (Pagina 16)

• Using and set the tare value,

• Press

• Program returns to weighings mode. The inscribed tare value

can be seen on the display with „–” sign,

• Tare can be inscribed anytime in weighings mode.

Notice:

1. You cannot inscribe a new tare value when the tare value in memory

is greater than zero. In the case of trying this the <Err3> message

will be displayed and short audible signal will be emitted.

2. Users can also enter up to 9 tare values to the scale memory

(see 14.10 of his manual).

10.3. Zeroing

To ZERO the scale press: .

The scale will display zero and following pictograms:

and .

Zeroing is only possible within the scope of ±2% of full scale. While

zeroing outside the scope of ±2% you will see <Err2>. Zeroing is

possible only in stable state.

Notice:

Zeroing is possible only within the ±2% interval of the maximal range.

If zeroing is performed beyond this range the <Err2> message and

short audible signal will be emitted.

- 16 -

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 67 68

Sin comentarios

Radwag PUE C/31H/Z Indicator Manual de usuario Pagina 16