Radwag MYA 5.3Y.F1 Microbalance Manual de usuario descargar pdf (Pagina 56)

- 56 -

Caution:

Remember:

• Total mass of all parts loaded on the weighing pan must not exceed the

maximal capacity (weighing range) of the balance;

• Total mass of all parts loaded on the weighing pan must not be lower

than value declared in parameter “Minimal reference mass”. Unless

this condition is met, the balance displays a message: <Too low sample

mass>;

• Mass of a single part must not be lower than 0,1 of balance’s reading

unit. unless this condition is met, the balance displays a message: <Too

low part mass>.

16.5. Acquiring part mass from database

A product record in the database of products features set of information which

identifies it. One of them is mass, which is used during part counting process.

Procedure:

When in working mode < Parts counting> press < Products database>

key, and then select desired product from displayed list.

Insert standard (reference) mass to balance’s memory

Procedure for adding standard (reference) mass of a single part to the

database of products:

a) Press < Setup > key followed by pressing < Database > key

b) In the Database of Products press < Products >

c) Press name of a product and edit data in field no. [5] Mass

d) Return to <Parts counting> mode.

If there are no data in the database:

a) Press < Setup > key followed by pressing < Database > key

b) In the Database of Products press < Add > key

c) Accept the process of adding a new record in the database

d) Fill in field referring to a product, including field no. [5] Mass

e) Return to <Parts counting> mode.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 197 198

Sin comentarios

Radwag MYA 5.3Y.F1 Microbalance Manual de usuario Pagina 56